Tightening torque:
Engine oil drain bolt:
43 Nm (4.3 m·kgf, 31 ft·lbf)
14. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter cartridge replace-
ment:
2.40 L (2.54 US qt) (2.11 Imp.qt)
With oil filter cartridge replacement:
2.60 L (2.75 US qt) (2.29 Imp.qt)
NOTE:
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
CAUTION:
G
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
PERIODIC MAINTENANCE AND MINOR REPAIR
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G
Make sure that no foreign mate-
rial enters the crankcase.
1. "CD" specification
2. "ENERGY CONSERVING II"
15. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking, im-
ECA11620
mediately turn the engine off and
check for the cause.
NOTE:
After the engine is started, the engine
oil level warning light should go off if the
oil level is sufficient.
CAUTION:
If the oil level warning light flickers
or remains on, immediately turn the
1
engine off and have a Yamaha dealer
check the vehicle.
16. Turn the engine off, and then
2
17. Install the cowling.
6-17
check the oil level and correct it if
necessary.
ECA10400
6