Data Format; Stop Bit Select; Check Parity - Symbol LS 1000 Reference Manual

LS 1000 Product Reference Guide: Chapter 4, Programming the LS 1004

Data Format

This parameter sets the transmit data format. The options are:
• 7 Data Bits (With Parity) (default)
• 8 Data Bits (With Parity)
• 8 Data Bits (Without Parity)
7-Bit

Stop Bit Select

The stop bit(s) at the end of each transmitted character marks the end of transmission
of one character and prepares the receiving device for the next character in the serial
data stream. The number of stop bits (one or two) selected depends on the number the
receiving terminal is programmed to accommodate. Set the number of stop bits to
match host device requirements.
1 STOP BIT

Check Parity

This option determines whether the parity of received characters is checked. The type
of parity used is selectable through the PARITY parameter.
Check Parity of Re-
ceive Data Enable
4-33
8-Bit
2 STOP BITS
Check Parity of Re-
ceive Data Disable