For Battery Operation - Symbol LS 1000 Reference Manual

LS 1000 Product Reference Guide: Chapter 1, Introduction and Setup
RS-232C (Contd)

For battery operation:

• Insert a 9-volt battery into the battery box. See
• Plug the scanner's 9-pin connector at the end of the cord into one end of the
battery box.
• An output cable from the battery box connects the LS 1000 to the RS-232C
input device. Connect one end of this cable to the battery box and the other
to the appropriate port on the host device.
Figure 1-4. RS-232C Operation
1-8
Battery Box Operation .