Completing The Parts Replacement - Lenovo ThinkCentre M72e Hardware Maintenance Manual

5. Remove the front antenna and cable from the front of the computer.
Figure 102. Removing the front WiFi antenna
6. To complete the installation or replacement, go to "Completing the parts replacement" on page 156.

Completing the parts replacement

After completing the installation or replacement for all parts, you need to close the computer cover and
reconnect cables. Depending on the parts you installed or replaced, you might need to confirm the updated
information in the Setup Utility program. Refer to Chapter 6 "Using the Setup Utility program" on page 57.
To close the computer cover and reconnect cables to your computer, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws
are left inside your computer. See "Locating major FRUs and CRUs" on page 78 for the locations of
various components in your computer.
2. If you have removed the front bezel, reinstall it. To reinstall the front bezel, align the three tabs on
the front bezel with the corresponding holes in the chassis and pivot the front bezel inwards until
it snaps into position.
3. Make sure that the cables are routed correctly. Keep cables clear of the hinges and sides of the
computer chassis to avoid interference with closing the computer cover.
4. Lower the optical drive bay.
5. Reinstall the computer cover.
6. If there is an integrated cable lock available, lock the computer.
7. Reconnect the external cables and power cords to the computer. See "Locating connectors on the
rear of your computer" on page 78.
8. To update your configuration, see Chapter 6 "Using the Setup Utility program" on page 57.
Note: In most areas of the world, Lenovo requires the return of the defective Field Replaceable Units (FRUs).
Information about this will come with the new FRUs or will come a few days after you receive the new FRUs.
156
ThinkCentre Hardware Maintenance Manual