ViewSat VS2000 ULTRA User Manual page 18

Digital satellite receiver
Hide thumbs Also See for VS2000 ULTRA:
Table of Contents

Advertisement

About the Receiver
Does not display LED on the
- Connect the power cord to the power outlet
front panel or the receiver has no power.
- Check if the receiver is in standby mode.
- Check if the video output port is firmly
No pictures on the screen
- Check if you have selected the correct
- Connect the audio cords properly.
No sound
- Check the volume level of the TV.
- Press "MUTE" key.
- Point remote control directly towards the
Remote Control does not operate
- Check and replace Alkaline batteries.
- Check the signal strength in the "Antenna
Poor picture quality
- If this is low, try adjusting the alignment of
On - Screen Error Messages
- Connect the antenna cable properly.
- Check the LNB. Please replace LNB if
- Check the position of the dish. Please realign
Searching Signal
- Check the signal strength in the "Antenna
Setup" menu.
Unrecognized smartcard
- Check the smartcard.
Please insert your smartcard
- Insert the smartcard.
properly.
connected to the TV.
channel or video output on your TV.
receiver.
Setup" menu.
your dish.
necessary.
dish if necessary.
: SMPS
: AC 95V~240V 50Hz / 60Hz
: 250V/T2A
: 950�2150MHz
: -65�-25dBm
: 75Ϊ Unbalanced
: 'F' Type Female
: 13V/18V, Max 500mA with Short Circuit Protection
: Frequency 22± 4KHz, Amplitude 0.6±0.2Vpp
: 1.0 & 1.2 Version Compatible
: PLL Frequency Synthesizer
: QPSK Demodulation(DVB-S)
: 1�45 MS/s
: Viterbi Convolutional Coding
Rate 1/2, 2/3, 3/4, 5/6, 7/8
: Reed Solomon Coding(204,188) T=8
: MPEG-2 ISO/IEC 13818-2
: MPEG-2 MP@ML
: 1�15 MB/s
: 4:3(Normal) & 16:9(Widescreen)

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VS2000 ULTRA and is the answer not in the manual?

Table of Contents

Save PDF