Setting a Permanent Room Temperature
Selecting a time program (switching times) (continued)
Heating phase 2 OFF
1-7
- - : - -
Changing the room temperature for a few days only
The following energy saving options are
available for times, when you are not at
home:
H You can completely shut down central
heating by pressing 9 (standby
mode).
Or..
H You can set the central heating to
minimum energy consumption (e.g. to
prevent house-plants from suffering
through cold). For this, select the
"Holiday program" j.
During the holiday program, all heating
circuits are heated with the selected
"Red. room temp.", but there will be
no DHW heating.
(continued)
Press the following buttons if you want
to delete a time phase:
1. ur for "Htg. time program".
If "Select htg. circuit" is
displayed and "1r" flashes:
H Select the heating circuit
with ⊕ / ⊝, to which the
central heating should apply.
H Confirm twice with
H "ur" again for the
"Heating time program".
2.
until the required "Htg. cycle 1
Off" is displayed.
3. ⊕/⊝ until " - - : - -" is displayed for
the end time.
4.
to confirm; until the boiler
water temperature is displayed.
Adjusting the Room Temperature
.
21