Customer Key Programming - Dodge Caliber Owner's Manual

16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
location. This number is required for dealer replacement
of keys. Duplication of keys may be performed at an
authorized dealer or by using the Customer Key Pro-
gramming procedure. This procedure consists of pro-
gramming a blank key to the vehicle electronics. A blank
key is one, which has never been programmed.
NOTE: When having the Sentry Key Immobilizer
System serviced, bring all vehicle keys with you to the
dealer.

Customer Key Programming

If you have two valid sentry keys, you can program new
sentry keys to the system by performing the following
procedure:
1. Cut the additional Sentry Key Transponder blank(s) to
match the ignition switch lock cylinder key code.
2. Insert the first valid key into the ignition switch. Turn
the ignition switch to the "ON" position for at least 3
seconds, but no longer than 15-seconds. Then, turn the
ignition switch to the "LOCK" position and remove the
first key.
3. Insert the second valid key into the ignition switch.
Turn the ignition switch to the "ON" position within 15
seconds. After ten seconds, a chime will sound. In
addition, the Vehicle Security Alarm Indicator Light will
begin to flash. Turn the ignition switch to the "LOCK"
position and remove the second key.
4. Insert a blank Sentry Key into the ignition switch. Turn
the ignition switch to the "ON" position within 60
seconds. After 10 seconds, a single chime will sound. In
addition, the Vehicle Security Alarm Indicator Light will
stop flashing. To indicate that programming is complete,
the indicator light will turn on again for 3 seconds and
then turn off.