Reprogramming A Single Homelink Button; Security; Troubleshooting Tips - Dodge Caliber Owner's Manual

Reprogramming a Single HomeLink Button

To re-program a channel that has been previously
trained, follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink button until
the indicator light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button, proceed with PRO-
GRAMMING HOMELINK Step #2 and follow all remain-
ing steps.

Security

It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for 20
seconds until the red indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 131
The HomeLink Universal Transceiver is disabled when
the Vehicle Theft Alarm is active.

Troubleshooting Tips

If you are having trouble programming HomeLink , here
are some of the most common solutions:
• Replace the battery in the original transmitter.
• Press the Learn Button on the Garage Door Opener to
complete the training for Rolling Code.
• Did you unplug the device for training, and remember
to plug it back in?
If you are have any problems, or require assistance,
please call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
3