Table of Contents
Advertisement
Step 1: Switching the regulator
The regulator in the image below has
been removed to illustrate this pro-
cedure.
1.
Remove the LP gas line.
2.
Remove the cap fitting from the
end of the NG gas regulator.
3.
Place the cap fitting over the LP
gas inlet.
4.
Insert a male flared fitting (
tor.
Power Burner
LTR50001100, Rev. A
You will need:
•
13 mm open end
wrench
•
Male flared fitting
(not provided)
•
Pipe compound suitable
for natural gas
not provided) in the NG gas regula-
If you are attaching a
flex hose to the regu-
lator, you will need a
fitting. The fitting re-
quires a male flare on
the input end with a
1/2" MPT on the output
end. The flared male in-
put end needs to be the
size of your flex tubing.
You can also connect
the regulator directly
to your NG gas service,
which will not require a
flared fitting.
NOTE: A flared
fitting is NOT
included.
www.calflamebbq.com
27
Advertisement
Table of Contents
