Unloading The Batteries - Citizen PD-22 User Manual

About the Power Source
4
Restore the battery protective sheet and set
two batteries above the battery protective
sheet according to the directions of the [+]
and [-] symbols as shown in the figure.
* Set each battery from the [+] side. They cannot be
inserted from the [-] side.
* Set the batteries in place one at a time.
2
5
Slide the battery cover up again to close it.

Unloading the batteries

First raise the release part (green) of
the battery protective sheet, remove
the two batteries from the top, then
lift up the battery release lever (red)
and remove the two batteries from the
bottom.
* Do not vigorously pull up the battery
protective sheet. It might break.
If the battery protective sheet has been removed, notify the store where you
bought them or a service center. If you use the printer with the protective sheet
removed, the batteries might short-circuit causing them to leak, overheat, or
crack.
20
3
1
4
Battery protective sheet
release part (green)
Battery release
lever (red)