Setting The Language; Memorizing Channels - Sansui HDLCD3700C Owner's Manual

Setting the language

You can choose from three different languages
(English, French and Spanish) for the on-screen
displays.
Select the language you prefer first, then
proceed with the other menu options.
1
To turn on the TV, press POWER.
(POWER indicator on the front of the unit
changes green. It may take approx. 10 seconds
for a picture to appear on screen.)
2
Press MENU. The menu screen will appear.
3
Press ▲ or ▼ to select "Setup", then press ▶ or
ENTER.
4
Press ▲ or ▼ to select "Language".
Setup
Closed Caption >>
Language English
Video Label >>
16
Backlight
Auto Shut Off Off
Reset >>
: Select : Adjust
NOTE:
• When you press MENU first time after purchase this
LCD TV, above screen will appear automatically.
5
Press ◀ or ▶ to select the desired language:
English, French (Français) or Spanish (Español).
6
Press EXIT to return to the normal screen.
NOTE:
• If no buttons are pressed for more than about 60
seconds, the MENU screen will return to normal
operation automatically.

Memorizing channels

This TV is equipped with a channel memory
feature which allows channels to skip up or down
to the next channel set into memory, skipping
over unwanted channels. Before selecting
channels, they must be programmed into the
TV's memory. To use this TV with an antenna, set
the Tuning Band menu option to the Air mode.
When shipped from the factory, this menu option
is in the Cable mode.
Air/Cable selection
1
Press MENU. The menu screen will appear.
2
Press ▲ or ▼ to select "Channel", then press
▶ or ENTER.
3
Press ▲ or ▼ to select "Auto Ch Memory", then
press ▶ or ENTER.
4
Press ▲ or ▼ to select "Signal Type".
5
Press ◀ or ▶ to select "Air" or "Cable".
Air - VHF/UHF channels
Cable - CABLE TV channels
Auto Ch Memory
Signal Type Cable
Automatic Search Start
: Select : Adjust
6
Press EXIT to return to the normal screen.
CABLE CHART
The chart below is typical of many cable system
channel allocations.
NOTE:
• It may take a few seconds for a digital channel
picture to appear on screen after being selected.
Automatic search
1
Press MENU. The menu screen will appear.
2
Press ▲ or ▼ to select "Channel", then press ▶ or
ENTER.
3
Press ▲ or ▼ to select "Auto Ch Memory", then
press ▶ or ENTER.
4
Press ▲ or ▼ to select "Automatic Search", then
press ▶ or ENTER.
Auto Ch Memory
Signal Type Cable
Automatic Search Stop
Analog Channel Found : 0
Digital Channel Found : 0
ENTER:Cancel
: Select
5
The TV will begin memorizing all the channels
available in your area.
• It may take from 15 minutes to 30 minutes to
complete memorizing digital cable channels.
Depending on the reception condition, a BAR
display may not advance for several minutes,
please be patient.
NOTE:
• Memorizing channels is best accomplished during
evening "PRIMETIME" hours, as more stations are
broadcasting digital signals. Memorizing channels
can only be accomplished while a station is
broadcasting a digital signal to set that channel into
memory.
• If you are unsure of the digital channels available
in your area, you may visit www.antennaweb.org to
receive a list based on your address or zip code.
Should you require further assistance you may call
our toll-free customer service line at 1-800-289-0980.
• New digital channels may be added to your area
periodically, it is recommended to perform the
"Automatic Search" procedure regularly.
17