Operating The Mdr1064 - Samson MDR1064 Owner's Manual

Operating the MDR1064

USING AN EXTERNAL EFFECT
If you prefer to use an external device for effects process-
ing, you can easily connect the unit using the MDR1064
AUX 2 bus. Follow the simple steps below to interface
your processor:
1. Connect the AUX 2 OUTPUT to the input of the exter-
nal effect processor.
2. Connect the outputs of the effect processor to the
AUX 2 RETURN located on the MDR1064's master
section.
3. Set the MAIN LEVEL control to the "5" position.
4. Raise the AUX 2 knobs for the channels to which you
want the external effect to be applied.
5. Set the input level of the external effect so that the
sound is not distorted and so that the effect's input
meter does not indicate a clipped signal.
6. Use the AUX RETURN 2 control to adjust the level of the effects processed by the external effects device.
PLAYING BACK A CD USING 2T TO MIX
The MDR1064 has a dedicated input for playing back a stereo device such as a CD, Tape or Mini Disk. Below is
a description of how you can play back a CD, Tape or MD using the MDR1064's 2 TRACK INPUT.
1. Turn the MAIN level control all the way down.
2. Press the 2TK TO MIX button down.
3. Adjust the MAIN LEVEL control in the master section
to the "5" position.
4. Start playback on the CD, Tape or MD player, and
use the MAIN LEVEL control to set the desired level.
RECORDING A MIX FROM THE MDR1064
You can record the audio from the MDR1064's mixer
section including the MIC, LINE, 2T IN and AUX inputs to
a Cassette deck, MD, DAT or any other type of recorder
using the 2T OUT outputs. Simply connect the
MDR1064's 2 TRACK OUT to the input jacks of the
recorder as shown in the diagram on the right and follow
the steps below.
1. Adjust the MAIN LEVEL control in the master section to the "5" position.
2. Set a clean signal using the recorder's input level controls and meters.
3. Press RECORD.
4. Play back using as described in the previous section "PLAYING BACK A CD USING 2T TO MIX".
14