Subscribe to Our Youtube Channel
Related Manuals for Caple WCF32
Summary of Contents for Caple WCF32
-
Page 1: Instructions For Use
INSTRUCTIONS FOR USE WINE CELLARS WCI45 & 46B Built-in WCF32 Freestanding For Spare Parts, Technical Advice or Product Service call the CAPLE HELPLINE on 0870 850 8734 1 of 8... -
Page 2: Important Warnings And Advice
• The manufacturer is not responsible for damage caused by incorrect, mistaken or irrational use. • Caple cannot be held responsible for any errors in this manual, or for any damage linked to or following the provision, performance or use of wine cellar. •... -
Page 3: Installation Instructions
INSTALLATION INSTRUCTIONS BEFORE TURNING ON THE WINE CELLAR ENSURE IT IS PERFECTLY LEVEL Your cabinet is equipped with 4 adjustable feet. However, we do recommend that you tighten the back feet to the maximum and use the front feet to create a level. Stainless Steel Plinth for WCi46B (Supplied separately) When the Wine Cellar is installed in the final position the stainless steel plinth should be fitted: Remove the protective tape from the adhesive strips on the rear of the plinth. -
Page 4: Safety Instructions
SAFETY INSTRUCTIONS Freestanding model WCF32 • The place you have selected for your cabinet should be well ventilated. • This is a FREESTANDING product and the sides and top of the cabinet must have a clear 10cm air gap to allow for cooling. •... -
Page 5: Setting The Temperature Controls
SETTING THE TEMPERATURE CONTROLS ELECTRICAL DUAL ZONE (Model WCI45B Set upper Set lower Lower chamber Upper chamber 1. Each cooling compartment of the wine cooler (upper & lower) is independently controlled. 2. To set the temperature: Connect the power cord to a properly grounded outlet. In the event of a power interruption, all previous temperature settings are automatically erased and each compartment will default to a preset temperature setting of: 6 c for... -
Page 6: Interior Lights
MANUAL CONTROL (Model WCF32) 1. The initial setting is NORMAL. Please run the wine cellar empty at least 30 minutes before adjustment. 2. “MAX” can be adjusted from 5 c to 9 c . “NORMAL” can be adjusted from 10 c to 14 “MIN”... -
Page 7: Troubleshooting Guide
TROUBLE SHOOTING GUIDE You can solve many common Wine Cellar problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the service engineer. PROBLEM POSSIBLE CAUSE Not plugged in. -
Page 8: Humidity Maintenance System
HUMIDITY MAINTENANCE SYSTEM The wine cellar is equipped with a system for maintaining the correct level of humidity. If humidity is too low, insert the small plastic reservoir on to the top rack of the wine cooler. Fill this reservoir 3/4 full with water. Check water level occasionally and refill as necessary. RECOMMENDED TEMPERATURE For keeping ALL TYPES OF WINES Wine service temperature (Provided as an indicator only)
Need help?
Do you have a question about the WCF32 and is the answer not in the manual?
Questions and answers