Factory Service; Non-Warranty Repairs; Proprietary Rights - Cary Audio Design CAD-1610-SE Operating Manual

FACTORY SERVICE

Careful consideration has been given to the design of your CAD-1610-SE to keep maintenance
problems to a minimum; however, it is possible that some problems may arise which cannot be cured
by tube substitution. After reading the Troubleshooting Guide at the end of this manual, we suggest
that you contact our Customer Service Department at phone number (919) 481-4494 to describe
your problem in detail. Do not return the CAD-1610-SE to the factory without a Return
Authorization Number from the Customer Service Department. Cary Audio Design will
assume no responsibility if the transportation company refuses to pay damage claim due to your
improper packing or lack of insurance should the unit be lost in shipment.

NON-WARRANTY REPAIRS

Cary Audio Design will provide repair service for its products charging on a time and expense
basis for the repairs.
WARNINGS
Make no attempt to put the CAD-1610-SE in service outside of the cabinet - Contact
with high voltages found in the unit can be fatal!!!
Completely remove AC power plug from the wall and allow 30 minutes for the high
voltage capacitors to discharge through bleeder resistors before attempting to
change tubes or clean the inside to the amplifier.
CAUTIONS
Never remove/insert AC plug when the unit is on or the
AC power switch is in the "ON" position
Obstruction of the top portion of the CAD-1610-SE will result
in tubes overheating

PROPRIETARY RIGHTS

Cary Audio Design has proprietary right in the design and components of its products. While
the purchaser is entitled to use the product for its intended purpose, use of the products for its
intended purpose, use of the product for copying, imitation, or reverse engineering is a violation
of these proprietary rights and is forbidden.