Power Requirements - Cary Audio Design CAD-1610-SE Operating Manual

CAD-1610-SE PLACEMENT
The CAD-1610-SE is designed for use inside homes. It must be protected from the elements and
temperature extremes. For example, avoid placing the amplifier in extremely hot locations such as
near radiators or other heating units. Its location among the user's audio components is not critical;
however, certain precautions must be taken.

POWER REQUIREMENTS

The CAD-1610-SE is designed to operate from house current mains. The design voltage is 117 VAC
at 50/60Hz (Foreign units 234 VAC at 50/60Hz).
CABLES
The speaker cables from the output posts of the CAD-1610-SE to the speaker system can be any
convenient length your set-up requires. Select speaker cables of sufficient size to preserve the
outstanding performance capabilities of your CAD-1610-SE. Heavy gauge #16 wire is suitable for
distances up to 10 feet; #12 for 25 feet. Most audio dealers will have proper speaker cable in stock
for this purpose. See Initial Setup Instructions (opposite page) for Speaker Out.
INTERCONNECTS
Signal input connect is made via the input jack on the rear of the CAD-1610-SE. See Initial Setup
Instrucctions (opposite page) for Interconnect input. The interconnect cables from the output of
the preamplifier can be any convenient length your set-up requires. The choice of a high quality
interconnect cable is important. Once again, your audio dealer will have the proper cables in stock
.
for this purpose