Service And Care; Care And Cleaning; Tube Replacement; Ac Power Fuse Replacement - Cary Audio Design SLI-100 Owner's Manual

SERVICE AND CARE

CARE AND CLEANING

The cabinet housing and front panel of the SLI-100 may be cleaned with a soft cloth and Windex
or a window cleaner. The frequency of cleaning will be governed by how many hours the SLI-100
is operated and by operating environment cleanliness.
CAUTION:
• Do not let any liquids spill into the vents on top of the unit.

TUBE REPLACEMENT

If it becomes necessary to replace the tubes in the SLI-100 amplifier, a matched quartet set of output
tubes of the same brand should be used. A new tube kit is available from Cary Audio Design. You
should get a few years or more from the output tubes with everyday usage and many, many years of
use from the 6922 & 6SN7 input tubes.

AC POWER FUSE REPLACEMENT

WARNING: When replacing the power fuse, make sure the unit is NOT PLUGGED IN.
The value for the AC fuse in US or non-US countries that support AC voltages from 100V-120V is 3A
250V slow blow fuse.
In countries that support AC voltages from 220V-240V, the AC fuse should be replaced with a 2A
250V slow blow fuse.
The AC fuse is located on the rear panel of the chassis below the AC inlet.

FACTORY SERVICE

Careful consideration has been given to the design of your SLI-100 to keep maintenance problems
to a minimum. Any problems or requests for service should be referred to our Customer Service
Department at 919-355-0010. DO NOT return the SLI-100 to the factory without a Return
Merchandise Authorization (RMA) number from our online Customer Service Center
(www.caryaudio.com).
Cary Audio will assume no responsibility if the shipping company refuses to pay for damage due to
your improper packing or lack of insurance should the unit be lost or damaged in shipment. Please
retain and always use the original shipping carton for shipping the player. Also, Cary Audio reserves
the right to return products sent in for service in a new box set at the customer's expense if the
original packing material was damaged in the initial shipment, or if it is deemed unsatisfactory to
use in return shipping.
12