Power Supply; Ac Power Requirements - Cary Audio Design SLP-98 Operating Manual

POWER SUPPLY:

AC POWER
REQUIREMENTS:
WIRE:
WARM-UP TIME:
INPUT AND
OUTPUT JACKS:
DUTY CYCLE:
POWER SWITCH:
SELECTOR:
LEFT BLUE LED:
OPERATE MUTE:
TAPE MONITOR:
RIGHT BLUE LED:
LISTENING LEVEL:
INPUT LEVEL LEFT: Individual control of left channel level feeding to master listening
INPUT LEVEL RIGHT:
PHONO:
of 1.4
2-6SN7 line stage
2-12AX7 (ECC83) phono section
2-12AU7 (ECC82) phono section output buffer
Full wave rectification, center-tapped, pi-network featuring a filter
choke.
100-130 volts AC / 50-60Hz at 50 watts
200-245 volts AC / 50-60Hz at 50 watts
EE Teflon Silver
5 minutes
Gold plated with Teflon® insert
Continuous duty all modes 24 hours per day
Front Panel Features
Rotary 3 position: off, stand-by, operate
5 Position rotary switch controlling input selection.
Indicates AC power "ON"
Mutes output of preamplifier
By-passes all inputs to activate incoming tape recorder signals
Indicates SLP-98 in tape monitor function
Master dual volume control equally controlling input signal to line
section preamplifier
level volume control
Individual control of right channel level feeding to master listening
level volume control
Rear Apron Features
These jacks are to be used with moving magnet or high output
moving coil cartridges with a recommended minimum output
millivolts
1.3
1.4
3