Table of Contents
Advertisement
INSTALLING THE HOOD
First temporarily mount a 2x4 ledger board 30" (762mm) from the finished
countertop. Then, remove the filters from the hood canopy and remove the shields
below the power ventilator. Secure the hood through the keyhole slots in the top of
the hood and/or the slot hole in the rear of the hood. Remove the temporary
support ledger.
Installation
Top
mounting holes
(both sides)
Temporary Support Ledger Installation
(9" Shown)
Figure 11
Top
mounting holes
(both sides)
Temporary Support Ledger Installation
(18" Shown)
Figure 12
15
Rear
mounting holes
Temporary
support ledger.
Rear
mounting holes
Temporary
support ledger.
Advertisement
Table of Contents
