Table of Contents
Advertisement
Installation instructions
Hints on safety
This appliance must be installed and connec-
ted by qualified personel. Please observe this
instruction, otherwise the warranty will not
cover any dmage which may occur.
During the installation and in case of a service fai-
lure the appliance must not be connected to the
mains.
The general rules for the operation of electric ap-
pliances, the provisions by the competent electri-
city supply board and the specifications of these
instructions for installation have to be strictly ad-
hered to.
Built- -in in the kitchen worktop
Electrical safety is to be ensured by professional
installation.
Protection against accidental contact according
to the regulations set by VDE or other local autho-
rities must be ensured by correct installation of
the appliances. The same refers to the back of the
appliance which, even in case of built--in solutions
away from the wall, must not be freely accessible.
Built--in cupboards have to be located and faste-
ned in a way that they are stable.
Note down the data from the rating plate of your
D
appliance in the printed rating plate form in this
manual. These numbers are needed in case of
service calls.
Installation dimensions
The opening in the cabinet must correspond to the
standard dimensions. The necessary information can
be found in the dimensional sketch.
The separation between the lower surface of the
D
hob and the parts of the furniture below it must be
at least 20 mm
The lateral separation between the sides of the
D
hob and the cabinet must be at least 55 mm, and
must be at least 55 mm from the rear panel.
distance from worktop
opening to the rear wall
55 mm
R5
19
20 mm
distance from worktop opening to
the left or right side wall or to a
high cupboard
50 mm
20 mm
Advertisement
Table of Contents
