How To Use - Electrolux Z430 Series Owner's Manual

HOW TO USE

Power Switch
1. This vacuum has a 3-position switch. O is
Off, I is "Suction Only," and II is "Suction and
Brushroll."
2. For bare floor cleaning use suction only (I). For
carpet cleaning, use suction and brushroll (II).
The nozzle allows for low profile cleaning. Airflow
under the nozzle automatically directs suction to
the edges and corners for maximum full width
cleaning.
Hose and Attachments
CAUTION: Turn off the power switch and
unplug the electrical cord to
service.
1. Pull the hose end from the hose retainer at the
bottom of the unit and the hose holder at the
top.
2. Turn the hose actuator valve counter clockwise
to direct air from the floor nozzle to the hose
end.
3. Attach hose wand, dusting brush or crevice
tool.
4. After using attachments, remove hose wand,
dusting brush or crevice tool, store in designated
holders.
5. Turn the hose actuator valve clockwise to direct
air from the hose end to the floor nozzle.
6. Wrap hose around the top hose holder and
re-attach at the bottom of the unit into the hose
retainer.
6
On/Off
Switch
1
2