MISCELLANEOUS OPERATIONS
Removal of the rear wheel.
- Removal of the exhaust system (see
page 25).
- Remove the nut and the washer (1).
- Remove the wheel.
Tightening torque: 12 m.daN.
Removal of the calliper.
Removal of the brake pads.
- Loosen the screw (1) that secures the calliper
to the yoke.
- Remove the 2 screws that secure the brake
calliper, but do not disconnect it (2).
Tightening torque: 2.6 m.daN.
- Remove the screw (1).
- Pivot the calliper relative to the yoke.
- Remove the calliper yoke.
Note: If the caliper is to be changed, the
hydraulic control must be slackened
off before removal.
30
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
2
1