Checks Before Handing Over To The Customer - PEUGEOT V-Clic Workshop Manual

SERVICE SCHEDULE AND COMMISSIONING
Remove the battery.
Remove the 6 filler caps and the vent plug.
Fill with electrolyte to the level marked "UPPER LEVEL".
The density shall be equal to 1.28 ± 0.01 Kg/L, that is to say a concentration of 32.3 to 34.7 %.
Peugeot electrolyte P/N: 739733 1/2 l, 752741 5 l.
Leave the battery to stand for around half an hour.
Top up if necessary.
Charge the battery for at least 6 hours with a current of 0.5A.
Refit the battery and connect the vapour vent pipe.
Connect the terminal with the red wire to the battery + and the terminal with the black and white wire
to the battery -.
Then, the battery level should be topped up if necessary, after fully charging, using distilled water only.

Checks before handing over to the customer.

Check the wheel nuts are tight.
Check nuts and bolts are tight.
Check brake adjustment and efficiency.
Check the tyre pressures cold.
Check operation of the lights, flashers, horn, and brake light.
Check the different warning lights work.
Carry out a road test.
7
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles