Electrolux CycloneXL Operating Instructions Manual page 3

1 2
3 4
7
5 6
8
9 10

Accessories
1* Telescopic tube 7 Accessories clip
* Extension tubes 8* Turbo nozzle
 Hose handle + hose 9* Parquet nozzle
 Combination floor 10* Feather duster
nozzle
 Crevice nozzle
6 Upholstery nozzle
Safety precautions
CycloneXL should only be used by adults and only for
normal vacuuming in a domestic environment. The
vacuum cleaner features double insulation and does
not need to be earthed. Disconnect the plug from the
mains before cleaning or maintenance of the vacuum
cleaner. Be sure to keep the vacuum cleaner in a dry
place. All servicing and repairs must be carried out by
an authorised Electrolux service centre.
Never vacuum:
• In wet areas.
• Close to flammable gases etc.
• When housing shows visible signs of damage.
Never vacuum:
• Sharp objects, fluids.
• Hot or cold cinders, lit cigarette butts, etc.
• Fine dust, for example from plaster, concrete, flour,
hot or cold ashes.
The above may cause serious damage to the motor
– damage which is not covered by the warranty.
Electrical cable precautions:
Regularly check that the cable is not damaged. Never
use the vacuum cleaner if the cable is damaged.
Damage to the machine's cable is not covered by the
warranty.
* Certain models only.
Before starting
11 Open the front cover on the machine and check
that the motor filter and the dust container filter
are in place. (See also Cleaning/replacing the
filters.)
1* Open the back lid on the machine and check that
the exhaust filter is in place.
1 Insert the hose until the catches click to engage
(press the catches to release the hose).
 Insert the hose into the hose handle until the
catches click to engage (press the catches to
release the hose).
1 Attach the extension tubes* or telescopic tube*
to the hose handle and nozzle by pushing and
twisting together. (Twist and pull apart to dis-
mantle.)
1 Extend the electric cable and connect it to the
mains. The vacuum cleaner is fitted with a cable
winder. Once the electric cable has been exten-
ded, it stays in that position.
16 To rewind the cable, press the cord rewinder
pedal. The cable will then rewind.
17a Start the vacuum cleaner by rotaring the power
control in the direction of the "Max" position.
Increase suction power by rotaring the control
further up to "Max" position. Stop the vacuum
cleaner by rotaring in the opposite direction to
"Off" position.
In order to achieve an optimal cyclone effect in the
cleaner, the power regulation should always be in the
"Max" position.
17b* Suction power can also be adjusted by using the
suction control on the hose handle.
18 Ideal parking position for pausing (18a) and
storing (18b).
* Certain models only.
11 12 13
14 15 16
17a 17b
18a 18b