Sewing Buttons - Brother 885-X06 Operation Manual

SEWING BUTTONHOLES AND BUTTONS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
1
3
1 Buttonhole fine-adjustment screw
2 Left side
3 Buttonhole appearance
If the left side is too open, turn the buttonhole
fine-adjustment screw with a large
screwdriver in the
If the left side is too tight, turn the buttonhole
fine-adjustment screw with a large
screwdriver in the
• This adjustment ensures both sides of the
buttonhole are the same.

Sewing buttons

Stitch
Stitch Length
Pattern
Name [mm
(inch)]
3
Zigzag F
Stitch (1/64)
Measure the distance between the
1
buttonholes and mark the fabric. Then
adjust the stitch width so that it is the
same as the distance between the holes in
the button.
Turn off the machine.
2
Change the foot to the button sewing foot
3
"M".
37
2
3
"–"
direction.
"+"
direction.
Stitch
Width
Foot Other
[mm
(inch)]
Button
Sewing Darning
Any
Foot Plate
"M"
Place the darning plate on the needle
4
plate.
Turn on the machine.
5
Put a button between the foot and the
6
fabric and make sure that the needle enters
the holes without hitting the button. If it
hits, see step .
1
At a slow speed, sew about 10 stitches.
7
CAUTION
●
Make sure the needle does not hit the
button during sewing. The needle may
break and you may be injured.
Pull the upper thread at the end of the
8
stitching to the wrong side of the fabric,
and then tie it with the bobbin thread.
Use scissors to cut the upper thread and
the bobbin thread at the beginning of the
stitching.