Sewing Buttons - Brother XM2701 Operation Manual

SEWING BUTTONHOLES AND BUTTONS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
1
3
Buttonhole fine-adjustment screw
1
Left side
2
Buttonhole appearance
3
If the left side is too open, turn the buttonhole
fine-adjustment screw with a large
" –"
screwdriver in the direction.
If the left side is too tight, turn the buttonhole
fine-adjustment screw with a large
" +"
screwdriver in the direction.
This adjustment ensures both sides of the
buttonhole are the same.

Sewing buttons

Stitch Stitch
Stitch Length Width
Pattern
Name [mm [mm
(inch)] (inch)]
3
Zigzag F
Any
Stitch (1/64)
Measure the distance between the
1
buttonholes and mark the fabric. Then
adjust the stitch width so that it is the
same as the distance between the holes in
the button.
Turn off the machine.
2
Change the foot to the button sewing foot
3
" M" .
39
Place the darning plate on the needle plate.
4
2
Turn on the machine.
5
3
CAUTION
Do not turn on the machine while
pressing down the foot controller.
Put a button between the foot and the
6
fabric and make sure that the needle enters
the holes without hitting the button. If it
hits, see step
At a slow speed, sew about 10 stitches.
7
Foot Other
Button
Sewing Darning
Foot Plate
CAUTION
" M"
Make sure the needle does not hit the
button during sewing. The needle may
break and you may be injured.
Pull the upper thread at the end of the
8
stitching to the wrong side of the fabric,
and then tie it with the bobbin thread.
Use scissors to cut the upper thread and
the bobbin thread at the beginning of the
stitching.
.
1