Rear Wheel - Yamaha YZFR6Y Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT

Rear wheel

To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
7
1. Axle nut
2. Drive chain slack adjusting bolt
3. Locknut
4. Brake caliper
5. Brake caliper bracket
2. Lift the rear wheel off the ground
according to the procedure on
page 7-39.
3. Remove the axle nut.
EAU25080 4. Loosen the locknut on each side of
the swingarm.
5. Turn the drive chain slack adjust-
EAU44951
ing bolts in direction (a) to loosen
the drive chain enough so it can be
EWA10821
removed from the rear sprocket,
and then push the wheel forward.
6. Remove the drive chain from the
rear sprocket.
TIP
G If the drive chain is difficult to re-
move, remove the wheel axle first,
and then lift the wheel upward
enough to remove the drive chain
from the rear sprocket.
G
The drive chain cannot be disas-
sembled.
7. While supporting the brake caliper
1. Wheel axle
To install the rear wheel
1. Install the wheel and the brake cal-
TIP
7-42
bracket, pull the wheel axle out,
and then remove the wheel.
NOTICE: Do not apply the brake
after the wheel has been re-
moved together with the brake
disc, otherwise the brake pads
will be forced shut.
[ECA11071]
iper bracket by inserting the wheel
axle from the left-hand side.
G
Be sure to insert the retainer on the
brake caliper bracket into the slot
in the swingarm.
EAU39171