Adjusting The Rear Brake Light Switch - Yamaha FZ6RY Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
TIP
If the specified clutch lever free play
cannot be obtained as described
above, proceed as follows.
1. Fully turn the adjusting bolt at the
clutch lever in direction (a) to loos-
en the clutch cable.
2. Remove cowlings A and B. (See
page 7-9.)
3. Loosen the locknut further down
the clutch cable.
4. To increase the clutch lever free
play, turn the clutch lever free play
adjusting nut in direction (a). To
decrease the clutch lever free play,
turn the adjusting nut in direction
(b).
7
2
1
(a)
(b)
1. Locknut (clutch cable)
2. Clutch lever free play adjusting nut (clutch
cable)
5. Tighten the locknut.
6. Install the cowlings.
7-25
Adjusting the rear brake light
switch
1
2
(a)
(b)
1. Rear brake light switch
2. Rear brake light switch adjusting nut
The rear brake light, which is activated
by the brake pedal, should come on just
before braking takes effect. If neces-
sary, adjust the rear brake light switch
as follows.
Turn the rear brake light switch adjust-
ing nut while holding the rear brake light
switch in place. To make the brake light
come on earlier, turn the adjusting nut
in direction (a). To make the brake light
come on later, turn the adjusting nut in
direction (b).
EAU22272