Yamaha FZ6RY Owner's Manual page 62

PERIODIC MAINTENANCE AND ADJUSTMENT
TIP
The coolant should be between the
minimum and maximum level marks.
2
3
1. Coolant reservoir
2. Maximum level mark
3. Minimum level mark
4. If the coolant is at or below the
7
minimum level mark, remove cowl-
ing C. (See page 7-9.)
5. Remove the coolant reservoir
breather hose from the guide, and
then remove the coolant reservoir
cap.
1
1. Coolant reservoir cap
2. Coolant reservoir breather hose
3. Guide
1
6. Add coolant to the maximum level
mark, and then install the coolant
reservoir cap. WARNING! Re-
move only the coolant reservoir
cap. Never attempt to remove
the radiator cap when the en-
gine is hot.
coolant is not available, use dis-
tilled water or soft tap water in-
stead. Do not use hard water or
salt water since it is harmful to
the engine. If water has been
used instead of coolant, replace
it with coolant as soon as possi-
ble, otherwise the cooling sys-
tem will not
7-17
2
3
Coolant reservoir capacity (up to the
maximum level mark):
7. Route the coolant reservoir breath-
NOTICE: If
[EWA15161]
1. Coolant reservoir breather hose
2. Guide
8. Install the cowlings.
be protected
against frost and corrosion. If
water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
the coolant as soon as possible,
otherwise the effectiveness of
the coolant will be reduced.
[ECA10472]
0.25 L (0.26 US qt, 0.22 Imp.qt)
er hose through the guide as
shown.
1
2