TECHNICAL ASSISTANCE Should you need help. First check our website at www.bulldogsecurity.com/wires.htm or call our toll-free Tech Support Hotline Monday through Friday 9AM-8PM and Saturday 10AM-4PM EST at 800-878-8007. You must give the following information: •Name •Telephone Number with Area Code (Fax number if applicable) •Year, Make, and Model of the vehicle •The model number of the system you are installing •The type of assistance you are requesting...
PASSLOCK I INSTALLATION NOTE: Never connect the wiring on the Passkey or Passlock system without first setting the dipswitch positions. Installing the unit with all dipswitches in the down or (0) position could cause damage in your vehicle and/or Passkey or Passlock system. 1.
FIGURE 2a FIGURE 2b Testing for Resistor Value, Passlock I Testing for Resistor Value, Passlock II White or Black/White Red/White To Instrument To Instrument Black Orange/Black The Passlock I The Passlock I Panel Cluster Panel Cluster Key Cylinder Key Cylinder Yellow or Black (IPC) Yellow...
WHITE (-) • Negative Input: Connect to a wire from the remote start system which provides (-) ground before and after the vehicle starts, but not during cranking. (WHITE WITH BLACK STRIPE 16 awg wire on a relay harness) BLUE • Resistor Relay Output #87: This wire will apply the selected resistor value to the Passlock system.
Need help?
Do you have a question about the 721 and is the answer not in the manual?
Questions and answers