Table of Contents
Advertisement
Installation
Levelling
The appliance must be level. Level the
appliance
by
adjustable feet (1) at the front of the
appliance.
If required the washer (2) can be
removed.
Reversing the Door
The side at which the door opens can be changed from the right side (as
supplied) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the appliance
must not be connected to the mains. Remove plug from the mains
beforehand.
Carefully tilt the appliance to the
back and place an adequate
object under it.
Take care to avoid the compressor
or the condenser touching the
ground.
Unscrew both adjustable legs at
the front.
Dismount the Lower door hinge
at the bottom on the right side.
To do this, unscrew the three
screws, and pull the door holder
down together with the door
holder pin. Remove the screw on
the left side, and screw it in on
the right side.
Remove the door by pulling it
downwards while keeping it
slightly opened.
Unscrew the upper hinge pin,
and screw it in on the opposite
side.
Put the door back in its place.
10
adjusting
the
two
2
1
Advertisement
Table of Contents
