Brinkmann PRO SERIES 9620 810-9620-0 Owner's Manual page 29

Side Table Holes
Side
Burner
Valve
Valve
Nozzle
Figure 1
Burner Venturi
Figure 2
Side Burner
Grate
Side Burner
Control Knob
Bezel
Step 16
Press the two raised points on the
back of the bezel into the
corresponding holes on the side
burner front panel. Then, firmly seat
the valve nozzle into the burner
venturi. Hold in place while you
perform Step 17.
Step 17
Insert the two screws that are
already attached on the side burner
valve through the corresponding
key holes on the side burner front
panel and bezel, from the back of
the side burner front panel.
Depending on the side burner
valve, you will be using either the
outside key holes (Figure 1), or the
inside key holes (Figure 2). Pull the
valve downward or upward to lock
into place. Then tighten the two
screws.
WARNING: Never use your grill
without leak testing all
gas connections and
hoses. See the section
on "Leak Testing" in
this manual for proper
procedures.
Step 18
Install the side burner control knob
onto valve stem.
28