Manual Program Search; Automatic Program Search; Program Selection From Memory; Saving A Program In The Memory List - Pro-Ject Audio Systems Receiver Box Instructions For Use Manual

Manual program search

Press the rotary selector repeatedly until the display shows MANUAL. By rotating the rotary selector the reception
frequency will be increased or decreased in 50kHz steps. The tuner is correctly adjusted for a stereo broadcast
when
A the largest number of bars are shown (signal strength meter) and
B two loudspeaker symbols are shown (F one loudspeaker symbol shows mono reception)
C the vertical bar is centred in the fine tuning display

Automatic program search

Press the rotary selector repeatedly until the display shows AUTO. Rotating the rotary selector clockwise starts
the automatic frequency scan upwards, anticlockwise starts it downwards. The maximum signal strength will
be adjusted automatically for each program found.

Program selection from memory

Press the rotary selector repeatedly until the display shows MEMORY. Rotating the rotary selector clockwise
will select the program with the next memory position up the list, anticlockwise will select the program with
the next memory position down the list. The program's memory position is shown to the right of MEMORY in
the display.

Saving a program in the memory list

The memory of the Pro-Ject Receiver Box can store up to 99 programs. Tune to the frequency of the program
to be stored. Press the rotary selector twice in rapid succession. The display will show STORE. Rotating the
rotary selector clockwise will select the next memory position up the list, anticlockwise will select the next
memory position down the list. Press once on the rotary selector to store the program at that position. The
display shows STORED.
Saving a program to a particular memory position overwrites any program already stored at that
position. The memory retains its contents through a power off/on cycle.

Replacing batteries

Proceed as follows:
•
Unlock and slide open the battery case cover
•
Replace the battery.
Make sure the battery is the right way round !
• Close the battery case cover
Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.
© Audio Trade GmbH · Pro-Ject Receiver Box · Revision 15.10.10/15.12.10
5