Making User Settings; About User Settings - Pace TDC776D Operator's Manual

About User Settings

Your installer should have made the correct settings to make sure your set-top is compatible with
your HDTV or TV. However you may wish to change some settings, for example if you purchase a
new HDTV. You can make the following settings and you can also reset them to the factory defaults.
• TV Aspect Ratio (the screen's width-to-height ratio, or shape)
• TV Display Capability (screen resolution)
• Auto Pillarbox
• Closed Captions
• Front Panel Brightness
• Hard Disk Sleep Mode (for energy saving)
• HDMI Settings
You use the buttons on the front panel of your set-top to make the settings and you can see them on
the front-panel display. You can also look at on-screen menus, but please note that, until your set-top
has been set up to match the display capability of your TV, these menus may not be visible.
Putting your set-top into "user settings mode"
1. Make sure that your set-top is turned on (POWER light is green).
2. Press the POWER button on your set-top, then, within 1 second, press the MENU button.
"ASPt" (or another of the 8 "words" shown right) should then appear on the front-panel display. If it
does not appear, press the MENU button again. You may also see the PACE USER SETTINGS menu,
shown right, on your TV screen.
3. When you have finished making changes (see pages 22 to 31), press the POWER button to
remove the PACE USER SETTINGS menu and return to normal viewing.

MAKING USER SETTINGS

POWER button.
MENU button front-panel display
PACE USER SETTINGS
TV Aspect Ratio
TV Display Capability
Auto Pillarbox
Closed Captions
Front Panel Brightness
Hard Disk Sleep Mode
HDMI Settings
Restore Defaults
Select[OK] Exit[POWER]
21