Test Printing And Operation Check - Brother PT-9200DX Service Manual

12] Test Printing and Operation Check

[
(1) Plug the AC cord into the machine.
(2) With the ON/OFF (
twice to perform test printing.
(3) During test printing, check if the tape is fed correctly for printing, and if it is
cut correctly.
If any problem is found, refer to CHAPTER IV TROUBLESHOOTING.
(4) Check that opening the cassette cover releases the roller holder assy from
the thermal head, and that closing the cassette cover crimps the roller
holder assy on the thermal head.
(5) Check that the FEED/CUT (
(6) Check that the ON/OFF (
LED (ON/OFF key) Display
Lights up in green.
Blinks in green.
Lights up in orange.
Blinks in orange.
Blinks in red.
Lights up in red.
) key held pressed, press the FEED/CUT (
) key operates correctly.
State of the LED Display
Data reception standby mode.
Data has been received.
No cassette is present in the data reception standby mode.
The cover is open while data is being received (before printing).
The cover is open in the data reception standby mode.
No cassette is present during printing.
Tape end.
Replace the cassette.
The cover is open during printing.
Communications error.
Buffer error.
Cutter jam (before and during printing, and when power is turned on).
EEPROM error.
RAM error.
II-49
) key operates correctly.
) key