Brother PT-9200DX Service Manual page 65

Error Message Displayed on Monitor
Wrong AC adapter connected.
Communication error between PC and
P-touch.
Communication error in the P-touch.
Transmission settings incorrect.
Not enough memory to print document.
Not enough disk space to spool
document.
Invalid port was specified.
Port being used for another application.
Error of unknown cause occurred.
Countermeasure Displayed on Monitor
(User Takes an Action Referring to This.)
Use the AC adapter designed exclusively for
this unit.
Check for the following.
Start up the Change Baud Rate Wizard.
However, the current job should be deleted
before starting it up.
A communication error occurs within the
P-touch due to an over-run error, a
communication buffer full error, etc.
Try again after the other application is
finished.
Make sure that there is enough free space on
the disk.
Select a valid COM port using the Control
Panel and Resume.
Try again after the other application is
finished.
(Caution)
If this error occurs, check for the following.
- Is a mail application which uses the same
port as the P-touch not running?
- Is transmission software that uses the same
port as the P-touch not being used
immediately before?
- Is the same port selected by more than one
P-touch units?
Unexpected error occurred. Make a copy of
the Fault Report sheet, fill in the necessary
information, and then fax it to your service
representative.
II-52