GE PGP990DENBB Owner's Manual & Installation Instructions page 27

9-pin receptacle on the bottom of the cooktop
and discard. Connect the 9-pin plug on the blower
assembly to the matching 9-pin receptacle on the
bottom of the cooktop. Secure the connector cover
to the cooktop using 3 screws, making sure the
power cord comes out the U-shaped opening with
the wires to the motor.
9-pin
connectors
11
Shut-off
valve
• For all connections, use a pipe sealant approved
by local codes and resistant to the activity of L.P.
gas.
• Install the pressure regulator in the gas line
as close to the cooktop inlet as possible to allow
clearance for ventilation ducting.
• Make sure the arrow on the body of the
regulator is pointing straight up and toward the
cooktop. Any other position will affect the output
pressure of the regulator. This arrow indicates correct
gas flow direction.
• Install a manual gas line shut-off valve in an
easily accessible location.
Connector
cover
Solid piping or
flexible connector
Union
Solid piping
or flexible connector
Pipe stub
27
11
Instead of using solid piping to connect to
the pressure regulator, an approved flexible metal
appliance connector may be used between the
shut-off valve and the pressure regulator,if local
codes permit.
Appropriate flare nuts and adapters are required
at each end of the flexible connector.
Make sure all the knobs are in the off position.
Hook up the gas line and check for leaks.
all connections have been leak tested.
Purchase a liquid leak detector or prepare a soap
solution of one part water, one part liquid detergent.
2. When all connections have been made, make sure
all cooktop controls are turned to
gas supply valve to
3. Apply the liquid leak detector or the soap solution
around all connections from the shut-off valve to
the cooktop.
A leak is identified by a flow of bubbles from the
area of the leak.
If a leak is detected, turn the gas supply
the fitting. Turn the gas on and test again.
1. If the leak persists, turn the gas supply off and
contact your dealer for assistance. Do not attempt
to operate the cooktop if a leak is present.
Disconnect the cooktop and the
individual shut-off valve from the gas supply
piping system during any pressure testing of that
system at test pressures greater than 1/2 psig.
Isolate the cooktop from the gas supply piping
system by closing the individual manual shut-off
valve to the cooktop during any pressure testing
of the gas supply piping system at test pressures
equal to or less than 1/2 psig.
Do not use the cooktop until
and turn the
Tighten