flex power
U s e r m a n u a l
2.3 Installation tips
Make sure that air circulates freely around the device. Air inlet openings are on the sides, and the hot air outlet opening is on the top. Do
•
not obstruct these openings. The base of Flex Power
using the stands.
3. Chassis mounting:
3.1 Mounting on a flat surface
Focal Flex Power
mixer amplifier is factory-fitted with 4 stands. They protect the support surface and prevent the chassis from sliding
2120
accidentally.
For mounting on a 19" rack, four self-adhesive stands are also supplied instead of the factory-fitted stands. If necessary, provide for the ventila-
tion of the rack. The following instructions must be followed (positioning tips) when choosing the location.
2120
also acts as a radiator. It must never be in direct contact with the support without
2120
ok
12