Lenovo M55p - ThinkCentre - 8808 Hardware Maintenance Manual page 66

Diagnostic Error Code
014-199-XXX Parallel port test failed, cause unknown
014-2XX-XXX 014-3XX-XXX Parallel port failure
015-000-XXX USB port Interface Test Passed
015-001-XXX USB port Presence
015-002-XXX USB port Timeout
015-015-XXX USB port External Loopback failure
015-027-XXX USB port Configuration/Setup error
015-032-XXX USB port Device Controller failure
015-034-XXX USB port buffer allocation failure
015-035-XXX USB port Reset condition detected
015-036-XXX USB port Register error
015-040-XXX USB port IRQ failure
015-195-XXX USB port Test aborted by user
015-196-XXX USB port test halt, error threshold exceeded
015-197-XXX USB port test warning
60
Hardware Maintenance Manual
FRU/Action
1. Go to "Undetermined problems" on page 76
2. Flash the system and re-test. See "Flash update
procedures" on page 375
3. Replace component under function test
1. External parallel device
2. System board
No action
1. Remove USB device(s) and re-test
2. System board
1. Remove USB device(s) and re-test
2. System board
1. Remove USB device(s) and re-test
2. System board
1. Flash the system. See "Flash update procedures"
on page 375
2. System board
System board
1. Reboot the system
2. Flash the system and re-test. See "Flash update
procedures" on page 375
3. Run memory test
4. System board
1. Remove USB device(s) and re-test
2. System board
System board
1. Run setup and check for conflicts
2. Flash the system. See "Flash update procedures" on
page 375
3. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
"Diagnostics, Test and Recovery Information" on
page 47
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test