Lenovo M55p - ThinkCentre - 8808 Hardware Maintenance Manual page 59

Diagnostic Error Code
000-027-XXX BIOS Configuration/Setup error
000-034-XXX BIOS Buffer Allocation failure
000-035-XXX BIOS Reset Condition detected
000-036-XXX BIOS Register error
000-038-XXX BIOS Extension failure
000-039-XXX BIOS DMI data error
000-195-XXX BIOS Test aborted by user
000-196-XXX BIOS test halt, error threshold exceeded
000-197-XXX BIOS test warning
000-198-XXX BIOS test aborted
000-199-XXX BIOS test failed, cause unknown
FRU/Action
1. Run Setup
2. Flash the system. See "Flash update procedures" on
page 375
3. Boot block
4. System board
1. Reboot the system
2. Flash the system. See "Flash update procedures" on
page 375
3. Run memory test
4. System board
1. Flash the system. See "Flash update procedures"
on page 375
2. System board
1. Flash the system. See "Flash update procedures"
on page 375
2. Boot block
3. System board
1. Flash the system. See "Flash update procedures"
on page 375
2. Adapter card
3. System board
1. Flash the system. See "Flash update procedures"
on page 375
2. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
"Diagnostics, Test and Recovery Information" on
page 47
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
"Diagnostics, Test and Recovery Information" on
page 47
2. Flash the system and retest. See "Flash update
procedures" on page 375
3. Go to "Undetermined problems" on page 76
1. Go to "Undetermined problems" on page 76
2. Flash the system and re-test
3. Replace component under function test
Chapter 7
.
Symptom-to-FRU Index
53