Lenovo M55p - ThinkCentre - 8808 Hardware Maintenance Manual page 64

Diagnostic Error Code
006-197-XXX Diskette interface test warning
006-198-XXX Diskette interface test aborted
006-199-XXX Diskette interface test failed, cause
unknown
006-25X-XXX Diskette interface Error
011-000-XXX Serial port Interface Test Passed
011-001-XXX Serial port Presence
011-002-XXX 011-003-XXX Serial port Timeout/Parity
error
011-013-XXX 011-014-XXX Serial port Control
Signal/Loopback test failure
011-015-XXX Serial port External Loopback failure
011-027-XXX Serial port Configuration/Setup error
011-03X-XXX 011-04X-XXX Serial port failure
011-195-XXX Serial port Test aborted by user
011-196-XXX Serial port test halt, error threshold
exceeded
011-197-XXX Serial port test warning
58
Hardware Maintenance Manual
FRU/Action
1. If a component is called out, make sure it is
connected and/or enabled
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test. See "Flash update
procedures" on page 375
3. Go to "Undetermined problems" on page 76
1. Go to "Undetermined problems" on page 76
2. Flash the system and re-test
3. Replace component under function test
1. Diskette drive cable
2. Diskette drive
3. System board
No action
1. Remove external serial device, if present
2. Run setup, enable port
3. System board
System board
System board
1. Wrap plug
2. System board
1. Run Setup, enable port
2. Flash the system. See "Flash update procedures" on
page 375
3. System board
System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
"Diagnostics, Test and Recovery Information" on
page 47
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test