Locating The Spare Retainer Bracket - Lenovo J200 Hardware Installation And Replacement Manual

Figure 14. Locating the spare retainer bracket
22
Hardware Installation and Replacement Guide
2. Remove the front bezel by releasing the three plastic tabs on the left side and
pivoting the bezel outward. Carefully set the bezel to the side without
disconnecting the power switch and LED assembly cable.
3. Remove the metal static shield from the drive bay using your fingers to pull it
outward.
4. If you are installing a drive with accessible media, such as an optical drive,
remove the plastic panel in the bezel from the bay by squeezing the plastic
tabs that secure the panel on the inside of the bezel.
5. If you are installing any type of drive other than a serial ATA hard drive,
make sure the drive that you are installing is set correctly as either a master
or a slave device.
Note: A serial ATA hard disk drive does not need to be set as either a master
or a slave device.
If you are installing an optical drive or a parallel ATA hard disk drive, set it as
a master device. Refer to the documentation that comes with your drive for
master/slave jumper information.
6. Remove the retainer bracket from the upper driver cage by sliding it
downward.