Replacing A Memory Module - Lenovo IdeaCentre K330 Replacement Manual

Replacing a memory module

Attention:
Do not remove the computer cover or attempt any repair before reading the
"Important safety information" in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM, go to the Support Web site at http://consumersupport.lenovo.com.
To replace a memory module:
1. Remove the computer cover. Refer to "Removing the computer cover".
Note: For this procedure, it helps to lay the computer on its side.
2. Locate the memory module connectors. Refer to "Locating components".
3. Remove the memory module to be replaced by opening the retaining clips as shown.
4. Position the new memory module over the memory connector. Make sure
that the notch
key on the system board. Push the memory module straight down into the
connector until the retaining clips close.
5. Refer to the "Completing the installation".
14
Hardware Replacement Guide
on the memory module aligns correctly with the connector