Cisco WS-C2950-24 Installation Manual page 104

Connecting Power
Install the plastic covers over the terminals. (See
Step 6
The safety cover is an integral part of the product. Do not operate the unit without the safety cover
Warning
installed. Operating the unit without the cover in place will invalidate the safety approvals and pose
a risk of fire and electrical hazards. Statement 117
Organize and secure the wires using cable ties as shown in Figure 2 or Figure 3. Make sure that the wires
Step 7
do not project above or below the front panel of the router.
Turn on power to the DC circuit. Be sure to remove tape used to secure the circuit-breaker switch in the
Step 8
OFF position.
Figure 3-21
Figure 3-22
Cisco 2900 and 3900 Series Hardware Installation
3-22
Wire Routing and Attachment for Cisco 2911 Routers
Plastic covers
Wire Routing and Attachment for Cisco 2921 and Cisco 2951 Routers
Plastic covers
Figure 3-21
-
+
+
-
G N D
-
+
+
-
Chapter 3 Installing and Connecting the Router
or Figure 3-22.)
Cable tie
From DC
power
source
Cable tie
From DC
power
source
OL-18712-01