Table of Contents
Advertisement
09
Using the sleep timer
The sleep timer switches the receiver into standby after a specified amount of time so you can fall asleep without
worrying about the receiver being left on all night. Use the remote control to set the sleep timer.
%
Press
to the receiver operation mode, then press SLEEP repeatedly to set the sleep
time.
30 min
Off
! You can check the remaining sleep time at any time by pressing SLEEP once. Pressing repeatedly will cycle
through the sleep options again.
! The sleep timer is valid for all zones. If any zone is on, the sleep timer continues functioning.
Dimming the display
You can choose between four brightness levels for the front panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.
%
Press
to the receiver operation mode, then press DIMMER repeatedly to change the
brightness of the front panel display.
! You can also choose to turn the display off. In this case, the FL OFF indicator lights.
Switching the HDMI output
Set which terminal to use when outputting video and audio signals from the HDMI output terminals.
The HDMI OUT 1 terminal is compatible with the Control with HDMI function.
%
Press
to the receiver operation mode, then press HDMI OUT.
Please wait a while when Please wait ... is displayed.
The output switches among HDMI OUT ALL, HDMI OUT 1 and HDMI OUT 2 each time the button is pressed.
! The synchronized amp mode is canceled when the HDMI output is switched. If you wish to use the synchro-
nized amp mode, switch to HDMI OUT 1, then select the synchronized amp mode on the TV using the TV's
remote control.
Checking your system settings
Use the status display screen to check your current settings for features such as surround back channel process-
ing and your current MCACC preset.
1
Press
to the receiver operation mode, then press STATUS to check the system
settings.
The front panel display shows each of the following settings for three seconds each: Input Source d Sampling
Frequency d MCACC preset d ZONE 2 input d ZONE 3 input d HDMI OUT.
2
When you're finished, press STATUS again to switch off the display.
60 min
90 min
Resetting the system
Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to MULTI ZONE OFF.
! Disconnect the iPod and USB memory device from the receiver beforehand.
! Set the Control with HDMI to OFF (see
HDMI Setup
1
Switch the receiver into standby.
2
While holding down ENTER on the front panel, press u STANDBY/ON.
The display shows RESET c NO d.
3
Select 'RESET' using PRESET k/l, then press ENTER on the front panel.
The display shows RESET? OK.
4
Press ENTER to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
! Note that all settings will be saved, even if the receiver is unplugged.
Default system settings
Setting
Digital Video Converter
SPEAKERS
Speaker System
Front
Center
FH/FW
Speaker Setting
Surr
SB
SW
Surround Position
Crossover
X-Curve
DIMMER
Inputs
See
Input function default and possible settings
on
HDMI
HDMI Audio
HDMI output
Control
Control Mode
ARC (Audio Return Channel)
PQLS
Standby Through
DSP
Power On Level
Volume Limit
76
Using other functions
on
page
66).
Default
ON
FH/FW ON
9.1ch FH/FW
SMALL
SMALL
SMALL
SMALL
SMALLx2
YES
IN REAR
80 Hz
OFF
Brightest
page
44.
AMP
HDMI OUT ALL
OFF
--- (OFF)
--- (OFF)
--- (AUTO)
OFF
LAST
OFF
Advertisement
Table of Contents
