Table of Contents
Advertisement
Fly 125 - 150 4T
Possible Cause
Defective piston sliding
Electrical system
Battery
Possible Cause
Battery
Turn signal lights malfunction
Possible Cause
Electronic ignition device failure
Steering and suspensions
Heavy steering
Possible Cause
Steering hardening
Check calliper and replace any damaged part.
BATTERY
The battery is the electrical device in the system
that requires the most frequent inspections and
thorough maintenance. If the vehicle is not used
for some time (1 month or more) the battery needs
to be recharged periodically. The battery runs
down completely in the course of 5 ÷ 6 months. If
the battery is fitted on a motorcycle, be careful not
to invert the connections, keeping in mind that the
black ground wire is connected to the negative ter-
minal while the red wire is connected to the termi-
nal marked+. Follow the instructions in the ELEC-
TRICAL SYSTEM chapter for the recharging of the
TURN INDICATOR NOT WORKING
With the key switch set to "ON" jump the contacts
1 (Blue-Black) and 5 (Orange) on the control unit
If by operating the turn indicator control the lights
are not steadily on, replace the control unit; other-
wise, check the cable harness and the switch.
STEERING HARDENING
Check the tightening of the top and bottom ring
nuts. If irregularities continue in turning the steer-
ing even after making the above adjustments,
check the seats in which the ball bearings rotate:
if they are recessed or if the balls are squashed,
Troubleshooting
Operation
Operation
batteries.
Operation
connector.
Operation
replace them.
TROUBL - 49
Advertisement
Table of Contents
Troubleshooting
