Cisco SD208T-NA Administration Manual page 42

Managing System Files
DHCP Auto Configuration
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business 200 Series Smart Switch Administration Guide
To configure DHCP server auto configuration:
Click Administration > File Management > DHCP Auto Configuration. The
Auto Configuration
page opens.
Enter the values.
• Auto Configuration Via DHCP—Select this field to enable DHCP Auto
Configuration.
• Backup Server Definition—Select By IP Address or By name to configure
the TFTP server.
Enter the following optional information to be used if DHCP Auto Configuration is
not enabled, or if it is enabled, but no configuration file was received from the
DHCP server.
• Backup Server IP Address/Name—Enter the IP address or the name of the
server to be used if no server IP address was specified in the DHCP
message.
• Backup Configuration File Name—Enter the path and file name of the file to
be used if no configuration file name was specified in the DHCP message.
The window displays the following:
• Last Auto Configuration Server IP Address—Displays the IP address of
the TFTP server last used to perform auto configuration.
• Last Auto Configuration File Name—Displays the last file name used by the
switch in auto configuration.
The Last Auto Configuration File Name is compared with the
NOTE
information received from a DHCP server when an IP address is received for
the switch. If this value does not match, the switch transfers the configuration
file from the server identified by the DHCP server into the Startup
Configuration file, and initiates a reboot. If the values match, no action is
taken.
Click Apply. The DHCP Auto Configuration feature is updated in the Running
Configuration.
4
DHCP
43