Cisco SD208T-NA Administration Manual page 130

Smartports
Common Smartport Tasks
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco Small Business 200 Series Smart Switch Administration Guide
Workflow2: To configure an interface as a static Smartport, perform the
following steps:
To enable the Smartport feature on the interface, open the Smartport > Interface
Settings page.
Select the interface, and click Edit.
Select the Smartport type that is to be assigned to the interface in the Smartport
Application field.
Set the macro parameters as required.
Click Apply.
Workflow3: To adjust Smartport macro parameter defaults, perform the
following steps:
Through this procedure you can accomplish the following:
• View the macro source.
• Change parameter defaults.
• Restore the parameter defaults to the factory settings.
1. Open the Smartport > Smartport Type Settings page.
2. Select the Smartport Type.
3. Click View Macro Source to view the current Smartport macro that is
associated with the selected Smartport Type.
4. Click Edit to open a new window in which you can modify the default values of
the parameters in the macros bound to that Smartport type. These parameter
default values are used when Auto Smartport applies the selected Smartport
type (if applicable) to an interface.
5. In the Edit page, modify the fields.
6. Click Apply to rerun the macro if the parameters were changed, or Restore
Defaults to restore default parameter values to built-in macros if required.
10
131