Cisco SD208T-NA Administration Manual page 135

Smartports
Configuring Smartport Using The Web-based Interface
STEP 1
STEP 2
STEP 3
NOTE
STEP 1
STEP 2
Cisco Small Business 200 Series Smart Switch Administration Guide
To apply a Smartport macro:
Click Smartport > Interface Settings. The Interface Settings page opens.
Reapply the associated Smartport macro in the following ways:
• Select a group of Smartport types (switches, routers or APs) and click
Reapply Smartport Macro. The macros are applied to all selected
interface types.
• Select an interface that is UP and click Reapply to reapply the last macro
that was applied to the interface.
The Reapply action also adds the interface to all newly-created VLANs.
Smartport Diagnostic.
If a Smartport macro fails, the Smartport Type of the interface is Unknown. Select
an interface which is of unknown type and click Show Diagnostic. This displays
the command at which application of the macro failed. See the workflow area in
Common Smartport Tasks
the macro after correcting the problem.
Resetting all Unknown interfaces to Default type.
Port Type
• Select the
Unknown
• Select
• Click Reset All Unknown Smartports. Then reapply the macro as described
above. This performs a reset on all interfaces with type Unknown, meaning
that all interfaces are returned to the Default type. After correcting the error
in the macro or on the current interface configuration or both, a new macro
may be applied.
Resetting the interface of unknown type does not reset the configuration
performed by the macro that failed. This clean up must be done manually.
To assign a Smartport type to an interface or activate Auto Smartport on the
interface:
Select an interface and click Edit. The Edit Interface Settings page opens.
Enter the fields.
• Interface—Select the port or LAG.
section for troubleshooting tips. Proceed to reapply
equals to checkbox.
and click Go.
10
136