Fabric Extender Image Management; Licensing Requirements For The Fabric Extender; Guidelines And Limitations - Cisco SD2008T-NA Configuration Manual

Fabric Extender Image Management

• slot identifies the slot number on the Fabric Extender.
• port identifies the port number on a specific slot and chassis ID.

Fabric Extender Image Management

No software ships with the Cisco Nexus 2000 Series Fabric Extender. The Fabric Extender image is bundled
into the system image of the parent switch. The image is automatically verified and updated (if required)
during the association process between the parent switch and the Fabric Extender.
When you enter the install all command, it upgrades the software on the parent Cisco Nexus Series switch
and also upgrades the software on any attached Fabric Extender. To minimize downtime as much as possible,
the Fabric Extender remains online while the installation process loads its new software image. Once the
software image has successfully loaded, the parent switch and the Fabric Extender both automatically reboot.
This process is required to maintain version compatibility between the parent switch and the Fabric Extender.

Licensing Requirements for the Fabric Extender

The following table shows the licensing requirements for the Cisco Nexus 2000 Series Fabric Extender:
Product
Cisco NX-OS

Guidelines and Limitations

The Cisco Nexus 2000 Series Fabric Extender has the following configuration guidelines and limitations:
• Beginning with Cisco NX-OS Release 5.2(1), the default port mode is Layer 3. Before Cisco NX-OS
Cisco Nexus 2000 Series NX-OS Fabric Extender Software Configuration Guide
10
The chassis ID ranges from 101 to 199.
The chassis ID is required only to access a host interface on the Fabric Extender. A
Note
value of less than 101 indicates a slot on the parent switch. The following port numbering
convention is used for the interfaces on the switch:
interface ethernet slot/port
Release 5.2(1), the default port mode was Layer 2.
License Requirement
The Cisco Nexus 2000 Series Fabric Extender
requires no license. Any feature not included in a
license package is bundled with the Cisco NX-OS
system images and is provided at no extra charge to
you. For an explanation of the licensing scheme, see
the Cisco NX-OS Licensing Configuration Guide.
Overview
OL-25816-02