Disassociating A Fabric Extender From An Interface; Associating A Fabric Extender To An F2 Module - Cisco SD2008T-NA Configuration Manual

Configuring the Fabric Extender

Disassociating a Fabric Extender From an Interface

Before You Begin
Ensure that you have installed and enabled the Fabric Extender feature set.
Ensure that you are in the correct VDC (or use the switchto vdc command).
SUMMARY STEPS
1. configure terminal
2. interface {ethernet slot/port | port-channel channel}
3. no fex associate
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
interface {ethernet slot/port | port-channel channel}
Example:
switch(config)# interface port-channel 4
switch(config-if)#
Step 3 no fex associate
Example:
switch(config-if)# no fex associate

Associating a Fabric Extender to an F2 Module

You can associate the Fabric Extender to an F2 module.
Before You Begin
Ensure that you have installed and enabled the Fabric Extender feature set.
• switch# configure terminal
• switch(config)# install feature-set fex
• switch(config)# feature-set fex
OL-25816-02
Purpose
Enters configuration mode.
Specifies the interface to configure. The interface can
be an Ethernet interface or a port channel.
Disassociates the Fabric Extender unit attached to the
interface.
Cisco Nexus 2000 Series NX-OS Fabric Extender Software Configuration Guide
Associating a Fabric Extender to a Fabric Interface
19